Comment · Tue, October 15, 2019 · Natrium Health & Nootropics Depot
Bacopa Monnieri - Standardised extracts (e.g Synapsa) and HPLC measurements
Original post in this thread
throw_my_username · 9 points
Hello,
I was wondering the following. Most studies on Bacopa use the Synapsa variant and state a dose of ~300mg with 50-55% bacosides.
Now, considering that that bacoside percentage is derived NOT through the accurate HPLC measurement but through UV-spectrophotometry, one can easily demonstrate that e.g Synapsa is, in fact, NOT 50-55% Bacosides but more like ~8% (for an example, see here).
Due to this, if one were to buy a product that claims 50% bacosides by HPLC, would it be reasonable to lower the bacopa recommended dosage by 5 times? So, instead of 300mg used in studies, the HPLC-measured variant would only be 60mg.
A second question I have is this: considering it's the same herb, how is it possible that some people have experienced problems with the non-Synapsa version of Bacopa? What could the Synapsa version have that the "generic" bacopa doesn't that could cause different reactions in the same person?
What they were answering
MindNutrition · 6 points
This is a real pain in the ass. The reports here are ours. We've had both SGS and Eurofins provide reports that stated the same values. Our manufacturer sends the lots off so they are sealed by the labs after testing, so the reports are ordered by them for us. I wouldn't have suspected that two reputable labs would have it wrong, yet here we are. Thanks for the all work you put in.
u/MisterYouAreSoDumb · Natrium Health & Nootropics Depot
If you want, you can send us some of your bacopa and we'll run it through the lab for free. If it comes out low, we'll let you handle that how you want. However, if it comes out good, let us know the supplier. Then it is a win/win and we can hold these suppliers accountable.